4650 EV8R . 4650 EV8R
Automatic Programmable Loop Application Unit
Automatic single head unit with two-needle clamp for attaching the loop in a single working cycle.
Ideal for jeans, chinos, dockers, sportswear, and casual and classic trousers in general.
The flexibility, productivity, reliability, and manufacturing simplicity of the 3650 EV8 units make them completely unique.
| The machine allows the belt loops to be attached in 4 different ways: | |
| A) | Normal - the two extremities of the loop are folded inwards about 0.8 cm with a minimum finished distance of the loop of 30 mm. This means that a loop can be applied onto even a small-sized waistband, typical in models for children and women. The unit can be fitted with a new device in order to give a calculated level of slack to the loop, up to 1.5 cm, to make sure that, after washing, the loop does not shrink and create tension on the belt. |
| B) | Sportswear/Semi-classic - The loop is applied as follows after first being cut to the required length. The upper extremity is not folded over, the lower part is about 3.5 cm long and is folded over when sewn onto the body of the trousers together with two bar-tacks. The result is that the lower bar-tack is seen on the loop while the upper bar-tack is placed inside and will subsequently be covered up when the belt is sewn. The minimum distance between the two seams is 24 mm. |
| C) | Classic – Once the straight loop (not folded at any end) is cut to the required length, it is applied to the rear side and stitched perfectly onto the trouser body by two bar tacks with a minimum distance of 20 mm. The upper tack is then covered in the waistband stitching operation on request. The minimum distance of the bar tacks can be only 11 mm, in the event of particular stylistic requirements for the trousers to be produced. |
| D) | Double loop - The first sewing operation is to fix the folded double loop to the trousers’ body. The attachment is preparing the loop, which has been folded twice, with two bar-tacks as shown in the picture. The second operation is to fix the waistband to the trousers’ body with a seam that will be covered by it. The third operation is to manually pull & sew the upper side of the loop by standard bar-tacking unit. |
| The machine is equipped with: | |
| - | New touch screen panel |
| - | Programmable bobbin counter with bobbin change signal |
| - | Series of Messages for ease of use/maintenance of the unit |
| - | 4 working Programs for the equipment: loading and pre-positioning the feet during the sewing stage, loading without pre-positioning, only sewing, and a step-by step function to check all the movements |
| - | Two rotary hooks with high loading capacity |
| - | Intelligent, self-adjusting device for discarding the tag-end |
| - | A loop cutting device that reduces noise level, sucks up the scraps, and increases the space available to the operator |
| - | Quick change of the loop size which is carried out by the operator |
| - | A needle distance of less than 35 mm and a mechanical device for releasing the lower head to change the bobbins |
| - | Two compensating pressure feet |
| - | Lamp for lighting up the sewing area |
| - | A Mitsubishi XLG 55420Y Servomotor complete with electronic panel of the XCGMFT2005 series with dedicated software. |
Requiring only 30 minutes to change from normal loop application to sportswear, diesel or classic application and vice versa.
PHOTO GALLERY
Downloads
SPARE PARTS EV8_Codici_Code.pdfEV8_Tavole_Parts.pdf |
DEPLIANT 4650EV8_Brochure.pdf |
INSTRUCTIONSEV8_English_Manual.pdf |
|